Name

Type

Function

Debug [Text]

Output

Error messages are displayed here. Attention: Diagnostics or debug outputs are only intended for the case of an error. Please use only after consultation with the support team! These may significantly affect the performance of the service when used.

Dynamic

Folder

For each output / zone, the data points for the controller are created here.

Volume - WLI Input

Output

Output of the current volume at the WLI input.

Volume - WMI/MIC Input

Output

Output of the current volume at the WMI / MIC input.

Driver On/Off

Bidirectional

Turns the driver on or off.

Driver State

Output

Returns the connection status "On / Off".

Name

Type

Function

Custom command

Input

To send a custom command (e.g. #|R001|F001|GSA|0|U|)

Custom command - Response

Output

System response to the user-defined command

Load default settings

Input

Resets the device to the factory settings.

Select input (All outputs)

Input

All outputs (zones) get the same input - the same source is played everywhere. This is not supported on the AMP523 MK2 model!

Save settings

Input

If this input is triggered, the device saves the current settings as a preset.

Mute (All outputs)

Input

This will silence all outputs. This is not supported on the AMP523 MK2 model!

Volume - WLI Input

Input

Adjust the volume when WLI is used.

Volume - WMI/MIC Input

Input

Adjust the volume when WMI / MIC is used.

Volume (All outputs)

Input

Adjust the volume for all outputs. This is not supported on the AMP523 MK2 model!

Line-Input (Output 9)

Input

Special setting for the line input (output 9). This is not supported on the AMP523 MK2 model!

IP-Address AMP

Enter the device IP address

Outputs/Zones

0

The outputs can be created in this editor.

Device-Address

R001

Device specific address.

Address

F001

Input of the local address (EisBaer) for the communication.

Driver On/Off

Turns the driver on or off by default.