|
<< Click to Display Table of Contents >> Navigation: Components > Driver > CIM [x2500] |
CIM (Common Interface Model)
The IEC 61968-9 specifies many of the functions related to meter reading and control. Typical uses of the message types include meter reading, controls, events, customer data synchronization and customer switching. Intended primarily for electrical distribution networks, IEC 6 1968-9 can be used for other metering applications, including non-electrical metered quantities necessary to support gas and water networks
Our CIM component implementation is done for controlling service point level smart devices in a distribution network. The interface complies with IEC 61968-9 Standard. Interfaces for Meter Reading and Control.
Data points
Name |
Type |
Function |
|---|---|---|
Debug [Text] |
Output |
Error texts are output here. These may e.g. with the "Log window" component. Attention: Diagnostics or debug outputs are only intended for the case of an error. Please use only after consultation with the support team! These may significantly affect the performance of the service when used. |
Debug verbose |
Input |
(DE) Enables extended debug output. Attention: Diagnostics or debug outputs are only intended for the case of an error. Please use only after consultation with the support team! These may significantly affect the performance of the service when used. |
Dynamic |
Folder |
The data points of the channels are displayed here. |
Driver On/Off |
Bidirectional |
(De) Activate the component. |
Last request |
Output |
Output for the last request as a text. |
Last response |
Output |
Output for the last answer as a text. |
Driver state |
Output |
Displays the status of the driver. |
Properties of the component
Name |
Standard |
Function |
|---|---|---|
Name/Type Authority |
|
If you are making your own room and group list, then you must use the name of your list. |
Device control commands |
0 |
This is where the commands are defined. |
Channels |
0 |
The devices can be imported or set here. |
Connection |
0.0.0.0:18100 |
Building Server: EisBaer can act as the “data collection server” for measurement and status information located in the building. The EisBaer server receives control commands and can keep a local database of status information and meter data. EisBaer can be connected to the bus systems used inside the apartments, from which it reads the data and control tasks the equipment. EisBaer is the provider of the CIM interface. Example: http(s)://<EisBaer-IP>:<PORT>/cim/
Target server: The target server is the subscriber to the CIM interface. It can send requests to EisBaer, which will respond to them. The requests can be different status and measurement requests or control tasks or subscriptions for transmission. Several servers can be connected to the same EisBaer server, and one target server can communicate with several EisBaer servers. |
Subscription queue size |
10 |
Setting for the maximum subscription queue size for accelerated transmission. |
Driver On/Off |
|
(De) Activate the component. |
The Building Server can be reached at: http(s)://<EisBaer-IP>:<PORT>/cim/