Diagnostics [Text]

Output

Error texts are output here. These can be displayed e.g. with the component"Protocol window". Attention: Diagnostic or debug outputs are only intended for error cases. Please use only with consultation of the support team! If used, these can considerably impair the performance of the service.

Dynamic

Folder

The data points of the devices are displayed here. There are subfolders per device for the functions. Depending on the device, there may be different functions and display options.

Extended Diagnosis

Input

(De)Activates the extended debug output. Attention: Diagnostic or Debug - Outputs are only intended for error cases. Please use only with consultation of the support team! If used, they can significantly affect the performance of the service.

Status

Folder

This folder contains the data points for the output of the status messages.

Driver On/Off

Bidirectional

(De)Activate the component

Interrupt

Input

Any signal is used to interrupt the heating process.

Boil water

Input

Any signal is used to start the heating process to boil the water.

Heat water (temperature + trigger)

Input

If a temperature is entered, the heating process starts up to the entered temperature.

Heat water (heating time minutes)

Input

Time preset in minutes, for keeping the water warm.

IP

The IP address of the iKettle kettle must be entered here.

Port

2081

Communication port of the iKettle.

Status Readout interval [s]

5

Time interval in seconds for status update.

Water Sensor Raw Value Minimum

2048

Sensor value when no water is filled in. The value must be determined in order to calculate the fill level.

Water sensor raw value maximum

4096

Sensor value when the water is filled to the maximum. The value must be determined in order to calculate the fill level.

Driver On/Off

(Dis)enable the component.