Components > Communication > KNX DataPoint Player

With the help of the KNX Telegram Player component, it is possible to send or query any number of group addresses on the KNX.

To use the component , itmust beconnected to the connection of the same name of the KNX component via the data point Status table. Any number of KNX telegram players can be used in parallel.

The group addresses and their functions are defined inthe telegram list ofthe component.

When the component is started by an On command on the Start/Stop input, the entries of the telegram listare sent to the KNX. While processing is running, the status output is On. If another On command arrives at the input during processing, this is discarded. Only after complete processing can this be restarted via an On command. If an Off command is received at the input, processing is stopped immediately.

Data points of the component

Name	Type	Function
Ready	Output	Outputs an on signal when the list has been processed.
Progress	Output	Indicates the progress in %.
In progress	Output	If the telegram list is being processed, the output is "On", if the processing is finished, the output is "Off".
Start/Stop	Input	The processing of the telegram list is started with an On signal. With an off signal, the processing is stopped.
Status table	Output	Connection of the component to the KNX component.

Properties of the component

Name	Standard	Function
Telegram list	0	The telegrams to be processed are defined here.
Transmission interval [ms]	50	Specifies the send pause between two telegrams in milliseconds.