Components > Driver > ZigBee LightLink

Data points of the component

Name	Type	Function
Diagnosis [Text]	Output	Error texts are output here. These can be displayed e.g. with the component "Protocol window". Attention: Diagnosis or debug outputs are only provided for the case of an error. Please use only after consultation with the support team! If used, these can considerably impair the performance of the service
Extended diagnostics	Input	(De)Activate the extended diagnostics.
Transmission response	Output	Output of the response telegrams when sending commands (JSON).
Status output	Output	Output of the transmitted telegrams in text form (JSON).
Status output (formatted)	Output	Output of the transmitted telegrams in text form (JSON) and with line break.
Driver On/Off	Bidirectional	Switch the driver on or off.
Connection status	Output	Outputs the status of the connection.

Properties of the component

Name	Standard	Function
Lights	0	In the channel editor "Lights" the lights/lamps can be imported.
Sensors	0	The sensors/switches can be imported in the "Sensors" channel editor. For remote controls/buttons, the number of buttons must be set.
Groups	0	The luminaire groups can be imported in the "Groups" channel editor.
Scenes	0	The scenes can be imported in the "Scenes" channel editor (if supported by the gateway). These are displayed in the groups as data points.
Connection	deConz ...	Opens the editor for setting the Zigbee Gateway (currently only deCONZ from Dresden-Elektronik). Enter the IP address of the gateway, the port (default 80) and a user name of your choice. Via a user key must be called up. For this purpose the gateway has to be "unlocked" before (via the webfrontend --> Settings --> Gateway --> Advanced --> Allow App-Connection for Thirdparty).
Controlling lamps individually with group command		If activated, the individual lamps concerned are controlled separately when a Group On command is given.
Ignore brightness for lamps that are switched off	X	This prevents lamps from being switched on when the value at the "Brightness" input changes.
Update interval [s]	10	Here you can set the update interval for the status query.
Color change delay [x100ms].	0	Defines the color change time in multiples of 100ms.
Driver On/Off		Here you can set whether the component should be active when the system is started.

In the folder for dynamic plc is a subfolder for the lights, groups, sensors and scenes created.

Another subfolder for each light is associated with the name is created. Among these are the following PLC:

-Alarm: Displays the current alarm status

-Alarm (no): Disabled Alarm

-Alarm (lSelect): Sets the alarm mode lSelect

-Alarm (Select): Sets the alarm mode select

-Effect color loop: Starts Collor loop effect

-Distance: Reachability Status

-Color blue: Entering the blue light color value (if supported)

-Color green: Enter the green light color value (if supported)

-Color red: Entering the rotwertes light color (if supported)

-Color mode: The light color mode

-Color temperature: Color temperature of the light current

-Color: Input/output of the Lamp color color tone (if supported)

-Brightness: Output/set the current brightness

-Manufacturer: Output of the manufacturer's name

-Lampen-Typ: Output of the lamp type

-The last effect: Output of the last effect mode

-Model-Id: Output of the model number

-Saturation: Input/output of the Lamp color saturation (if supported)

-Turn off: The lamp on/off (or output of the status)

-SW version: Output from the SW version

-Unique ID: The unique ID of the light output

For each group, another subfolder with the corresponding name is created. Among these are the following PLC: