Forum

Hi I'm trying to install Eisbaer 1.8 on a new Windows 10 pc.
To connect to the Network I've used the very old ABB IG/S 1.1 before which also works fine on the new pc with Eisbaer 1.8 with "driver type" set to "IGS".

I'm tying to change it to ABB's new IPR/S 3.1.1. But I cant get it to Work. (only in ets5 it Works)

Under Eisbaer runtime selecting menu "Tools"->"Settings" a window called "Project configuration" opens. Then clicking "Systempage"->"KNX1 "

Connection:
Driver on/off - Set
Driver type - KNXnet/IP
Initializing - Set
Telegram Delay - 100

KNX:
IP-Adress;Port;IA - 224.0.23.12;3671;15.15.15 (This is found automatic by Eisbaer).
in real life the 'ipr/s3.1.1' ip adr is 10.19.116.11 & knx adr. is 0.0.0

I get an error message then clicking the "Driver on/off" to "on"
See attached image
It dosent matter if ets5 is running at the same time or not.
If ets5 is running with Group monitor started the Group monitor will stop/pause showing traffic as long Eisbaer is running until Eisbaer is exit'ed the groupmonitor resumes automaticly

Dear KennyP,

I sent you an email...