Enterprise OID

1.3.6.1.4.1.44301

Here you can enter the Enterprise-Object ID. This is used for all traps when trap version 1 is set.

Channels

0

Custom traps can be created here. The specification of the trap number is only relevant if SNMP is set to version 1. Furthermore, the trap-specific object ID and the data type of the trap value can be defined. There are the types: Bool, Double, Int32, UInt32 and String available.

Heartbeat interval [s]

60

Here you can define the interval in which the standard trap (version, solution, project) is sent.

Local IP

Here, the IP address of the local network interface to be used is entered.

Agent Port

161

Here you enter the local port to be used by the agent component.

Manager IP

The IP address of the computer to which the traps are to be sent is specified here. The IP address must be specified.

Manager Port

162

This specifies the port associated with the remote SNMP trap recipient.

SNMP Trap Version

one

Opens the editor for setting the trap version. If V3 is used, the authentication and encryption passwords and the associated protocols can be specified.

V2 Module Identity

Opens the editor for setting the agent identity (only relevant for trap version 2 or 3)

Driver On/Off

This can be used to set whether the component should be active when the system is started.

Debug [Text]

Output

Error messages are displayed here. The diagnostic information is displayed there, linked to the [Signal] input of the log window.

Driver On/Off

Bidirectional

Switch the driver on/off.

Dynamic

Folder

Contains the data points of the created channels

Channel001

Input

Here, the associated value inputs are created for each defined trap. If a value is sent to the component via one of these SPs, a corresponding trap with the received value is generated as content and sent to the defined trap receiver.